The solubility of silver bromide at the new temperature must be known. Normally the solubility increases and some of the solid silver bromide will dissolve.
(a) 6.4 10−9 M = [Ag+], [Cl−] = 0.025 M.
Check: an insignificant change;
(b) 2.2 10−5 M = [Ca2+], [F−] = 0.0013 M.
Check: This value is less than 5% and can be ignored.
(c) 0.2238 M = [Ag+] = 7.4 10–3 M.
Check: the condition is satisfied.
(d) [OH–] = 2.8 10–3 M; 5.7 10−12 M = [Zn2+].
Check: x is less than 5% of [OH–] and is, therefore, negligible.
(a) The change in initial concentration of common ion may not be neglected (must solve quadratic equation)
[Ti+] =0.031 M
[Cl–] = 0.0056 M
(b) The change in initial concentration of common ion may be neglected.
[Ba2+] = 2.4 10–4 M
[F–] = 0.313 M;
(c) The change in initial concentration of common ion may be neglected.
[Mg2+] = 0.0244 M
(d) The change in initial concentration of common ion may be neglected.
[Ca2+] = 5.18 10–4 M
[C2)42–] = 0.051 M
The changes in concentration are greater than 5% and thus exceed the maximum value for disregarding the change.
CaSO4∙2H2O is the most soluble Ca salt in mol/L, and it is also the most soluble Ca salt in g/L.
7.8 10–3 M = = [Ca2+]; Since this concentration is higher than 2.60 10–3 M, “gyp” water does not meet the standards.
(a) [Ag+] = [I–] = 1.3 10–5 M; (b) [Ag+] = 2.88 10–2 M, = 1.44 10–2 M; (c) [Mn2+] = 3.7 10–5 M, [OH–] = 7.4 10–5 M; (d) [Sr2+] = 4.3 10–2 M, [OH–] = 8.6 10–2 M; (e) [Mg2+] = 1.3 10–4 M, [OH–] = 2.6 10–4 M.
(a) CaCO3 does precipitate. (b) The compound does not precipitate. (c) The compound does not precipitate. (d) The compound precipitates.
(a) and Cu2+: Add (b) and Cl–: Add Ba2+. (c) Hg2+ and Co2+: Add S2–. (d) Zn2+ and Sr2+: Add OH– until [OH–] = 0.050 M. (e) Ba2+ and Mg2+: Add (f) and OH–: Add Ba2+.
MnCO3 will form first since it has the smallest Ksp value among these homologous compounds and is therefore the least soluble. MgCO3•3H2O will be the last to precipitate since it has the largest K_sp value and is the most soluble. Ksp value.
(a) (b) The electronic and molecular shapes are the same—both tetrahedral. (c) The tetrahedral structure is consistent with sp3 hybridization.
(a) Ksp = [Mg2+][F–]2 = (1.21 10–3)(2 1.21 10–3)2 = 7.09 10–9
(b) 7.09 10–7 M
(c) Determine the concentration of Mg2+ and F– that will be present in the final volume. Compare the value of the ion product [Mg2+][F–]2 with Ksp. If this value is larger than Ksp, precipitation will occur.
0.1000 L 3.00 10–3 M Mg(NO3)2 = 0.3000 L M Mg(NO3)2
M Mg(NO3)2 = 1.00 10–3 M
0.2000 L 2.00 10–3 M NaF = 0.3000 L M NaF
M NaF = 1.33 10–3 M
ion product = (1.00 10–3)(1.33 10–3)2 = 1.77 10–9
This value is smaller than Ksp, so no precipitation will occur.
(d) MgF2 is less soluble at 27 °C than at 18 °C. Because added heat acts like an added reagent, when it appears on the product side, the Le Châtelier’s principle states that the equilibrium will shift to the reactants’ side to counter the stress. Consequently, less reagent will dissolve. This situation is found in our case. Therefore, the reaction is exothermic.
BaF2, Ca3(PO4)2, ZnS; each is a salt of a weak acid, and the from perchloric acid reduces the equilibrium concentration of the anion, thereby increasing the concentration of the cations
Effect on amount of solid CaHPO4, [Ca2+], [OH–]: (a) increase, increase, decrease; (b) decrease, increase, decrease; (c) no effect, no effect, no effect; (d) decrease, increase, decrease; (e) increase, no effect, no effect